Thread: Radial Engine Powered Motorcycle
View Single Post
  #2 (permalink)  
 Old 1 Dec 06, 02:59 PM
MA5K MA5K is offline
Wel dun McLaren
  
MA5K is doing research on fun.MA5K is doing research on fun.MA5K is doing research on fun.MA5K is doing research on fun.MA5K is doing research on fun.MA5K is doing research on fun.MA5K is doing research on fun.MA5K is doing research on fun.MA5K is doing research on fun.MA5K is doing research on fun.MA5K is doing research on fun.
Send a message via MSN to MA5K Send a message via Yahoo to MA5K
Rep Power: 18
Nickels: 6,763.61
Bank: 27,340.62
Default Re: Radial Engine Powered Motorcycle


Rotec R2800:
  • 1 x 40mm Bing Carburetor& Rubber Coupling and 2 x Hose Clamps
  • 1 x Starter Motor & Nyloc M 10 Nuts
  • 1 x Alternator and Alloy Spacer inc. Bolts Nyloc nuts and Washers.
  • 7 x Exhaust Stubs & 14 x Bolts & Washers
  • 1 x Prop Washer & 6 x Bolts & Washers
  • 1 x Ignition Module & Heat Sink Cream
  • 1 x 12 Volt Ignition Coil (Auto Style)
  • 1 x Magneto Trigger (Solid State)
  • 2 x Rotor Buttons (Ignition)
  • 1 x Ignition Wiring Harness
  • 1 x Oil Filter Block & Auto style filter Including Filter
  • 1 x In line oil filter between dry sump and scavenge pump
  • 2 x Steel Top Engine Mount Cups (Weldable)
  • 2 x Steel Lower Engine Mount Pins (Weldable)
  • 4 x Sets (8 pcs) Rubber Engine Cushions
  • 2 x Lower Engine Mount M8 Cap Screws &
  • Nyloc Nuts
  • 2 x Lower Alloy Stepped Mount Washers
  • 2 x Upper Engine Mount Nyloc M 10 Nuts
  • 2 x Upper Mount Plain Alloy Washers
  • 2 x Upper Mount Flared Steel Inner Sleeves
  • 1 x Operations and Service Manual
  • Factory Direct Tech Support
Last edited by MA5K; 1 Dec 06 at 03:02 PM.
Reply With Quote